AEKE S1 Pro handles or Resistance Controller won't connect
Pull down the Bluetooth toolbar, turn the accessory on, and tap it when it appears. If one accessory won't connect while others do, turn Bluetooth off and on in the Bluetooth list, remove the accessory and pair it again.
Pair an accessory
- Smart Grips: pull down the Bluetooth toolbar, briefly press the grip button until its light turns on, then tap the grip when it appears.
- Resistance Controller: before first use, remove the insulating strip from the back. Briefly press the button; when the light turns on, tap the pairing prompt on the screen.
Some accessories connect, others don't
If other accessories connect normally, the machine's Bluetooth is working and the issue is likely the accessory itself.
- Open the Bluetooth list and turn Bluetooth off and on.
- Remove (unpair) the accessory that won't connect and pair it again.
- If it still fails, send a fault report.
Replace the Smart Grip battery
S1 Pro Smart Grips use a replaceable battery.
- Press the release button on the end cap to unlock it.
- Pull the end cap out of the handle.
- Remove the battery from the compartment.
- Insert a new battery of the same type, matching the + / – polarity marks.
- Push the end cap back in until it clicks.
If you aren't sure which battery to use, check the markings on the old battery or contact us before replacing it. The grips aren't waterproof; wipe them with a damp towel and let them air-dry.

Still not fixed?
Contact us after sending the fault report and tell us which accessory won't connect.
Please include:
- Serial number (SN)
- Which accessory (e.g. right Smart Grip)
- A short video
If a fault could be unsafe, don't repeat it just to record a photo or video; send what you already have.
